The beeper sounds five times and all the lights blink. If the printer still does not print correctly contact your dealer. Turn off the printer and check for a paper jam, a ribbon jam or other problems. The printer makes a strange noise, the beeper sounds five times, and the printer stops abruptly. The ribbon cartridge may not be installed properly. The printer sounds like it is printing, but nothing is printed. The Paper Out and Pause lights are on and the printer beeps three times. Then, click the Ports or Details tab and select the appropriate port. When the icon of the printer you are using appears, right-click it and select Properties.
Epson lx 300 ii service manual windows#
For Windows XP, click Start, Control Panel, then click Printers and Faxes. The printer port may not be set correctly.įor Windows 98, Me, 2000 or Windows NT 4.0, click Start, point to Settings, then click Printers. Make sure the cable meets both the printer and computer specifications. The interface cable may not match the specifications of the printer or computer.Ĭheck both ends of the interface cable.
Epson lx 300 ii service manual software#
The software may not be installed properly.Ĭheck that the software is installed properly for your printer, as described in the Start Here. The PAUSE light is off but nothing is printed. Do not reconnect the power cord to an electrical outlet. If the voltages do not match, unplug the printer and contact your dealer immediately. The voltage ratings of the printer and electrical outlet may not match.Ĭheck that the printer's voltage rating matches the voltage of your electrical outlet. The lights stay off even when the power is turned on again. The lights come on briefly and then go off. Plug another electrical device, such as a lamp, into the outlet to determine whether the outlet is operating properly.
If the electrical outlet is controlled by an outside switch or automatic timer, use a different outlet. The lights on the control panel do not go on.Ĭheck that the power cord is properly plugged into the electrical outlet.
The printer prints all the codes it receives in hexadecimal format. Next, hold down the Load/Eject and LF/FF buttons while you turn on the printer. To print a hex dump, turn off the printer. If you are an experienced user or a programmer, you can print a hexadecimal dump to isolate communication problems between the printer and computer. If the self test does not work, contact your dealer or a qualified service person for assistance. If the self test works properly the problem probably lies in the computer, the application software, or the interface cable. You can check the operation of your printer using the self test. Most problems you may encounter while operating your printer have simple solutions.